Luminato satellite receiver

Besides multi-standard receivers the Luminato platform supports a cost efficient receiver dedicated to satellite reception. It enables flexible selection of free-to-air services from DVB-S/S2 sources, which can be adjusted to the operator’s service line-up with the built-in advanced transport stream processing capabilities. The selection between DVB-S and DVB-S2 standards can be done from a intuitive user interface without any hardware changes.

Category:

Description

Features:

  • Multiple services per receiver – high efficiency, lower investments
  • Embedded security – services can’t be accessed in unprotected format
  • Hot swap as standard – swap the module and remain the configurations
  • LNB power feed, adjustable Voltage and 22 kHz tone
  • DVB-S/S2 IF reception
  • Advanced transport stream processing
  • Demultiplexing from MPTS to  SPTS
  • PID remapping and filtering
  • PSI/SI pass-through or regeneration
  • Service follow up, service ID remapping, stream type filtering, SID follow up and service information
  • Automatic/manual PSI-SI table generation
  • Multicast and unicast streaming
  • MPEG transport stream over UDP/IP or RTP/UDP/IP streaming
  • SPTS and MPTS streaming (CBR or VBR)
  • MPTS passthrough

Specifications:

Satellite Receiver RF input – DVB-S/S2
Parameter Specification Note
Impedance 75 Ω
Frequency Range 950 … 2150 MHz
AFC Range 8 MHz
Constellation QPSK, 8PSK 16APSK 1)
FEC modes (autodetected) All ratios compliant with ETS302307
Signal levels -70 … -25 dBm
Symbol rate 1,5…47 MS/s
Max components per service 32
1,5…31,5 MS/s
1,5…47 MS/s
QPSK
8PSK
16APSK 1)
Transport Stream Bitrates per RF input 90 Mb/s
72 Mb/s
descrambling not used
descrambling in use
Standard ETS300421, ETS302307

 

DVB Common Scrambling Algorithm Content Protection
Parameter Specification Note
Max service to be scrambled per module 120

 

IP Streaming
Parameter Specification Note
Packet format 1…7 DVB transport packets in UDP/IP, RTP/UDP/IP
Traffic type Unicast or multicast
Max. IP streamer per module 120
Max. streaming capacity per module 394 Mb/s
490 Mb/s
DVB scrambling
AES scrambling
Traffic shaping Max peak traffic limiter

 

LNB Power
Parameter Specification Note
Adjustable voltage 13/18 v
22 kHz tone on/off
Max output current per connector 500 mA Total LNB power must be less than main PSU capacity minus installed mod­ule power consumption

 

General
Parameter Specification Note
Supply voltages 24 V
Power consumtion 7 W LRS-D
Connectors, RF F
Dimensions (h x w x d) 20 mm x 109 mm x 253 mm Dimensions excluding connectors and locking screws
Weight 0,3 kg
Enclosure classification IP21
Operating temperature -10…+55 °C
Storage temperature -30…+70 °C
Specification is met 0…+45 °C

Note:
1) 16APSK only available in RF1 and RF3 in quad DVB-S2 module (RF2 and RF4 disabled)